TRI-CENTRAL SCHOOLS

To view the full report for a bus inspection, click on the PDF icon on the right.

• Any seat back or bottom is loose
• There is debris in the bus. (needs cleaned/includes dirt)

• Upholstery or padding is ripped, torn, or improperly repaired
• Any belt is improperly adjusted
• Any exhaust leak can be felt with the bare hand six (6) inches from the leak in any direction (with the engine idling and the system unrestricted).

• There are attachments to the wheel
• Any seat back or bottom is loose

• If equipped the emergency warning buzzer does not sound

• Any seat back or bottom is loose

• Any seat back or bottom is loose

• Step-well light is missing or inoperative
• If equipped the emergency warning buzzer does not sound

• Step-well light is missing or inoperative
• If equipped the emergency warning buzzer does not sound
• The bus body has rust or rusted through areas which may weaken the body
• If bus manufactured after 5-2-1994, positive door opening device is missing or fails to operate properly

• Step-well light is missing or inoperative
• If equipped the emergency warning buzzer does not sound
• The bus body has rust or rusted through areas which may weaken the body
• If bus manufactured after 5-2-1994, positive door opening device is missing or fails to operate properly

• Any seat back or bottom is loose
• Warning lights fail to operate correctly
• If equipped the emergency warning buzzer does not sound
• The mirrors do not meet the outside mirror standard as set forth in 575 IAC 1-2-49

• Step-well light is missing or inoperative

• There is no seat belt cutter in the vehicle
• Any marker light or lens is missing, cracked, faded, wrong color, or inoperative
• Any brake line or hose is abraded (chafed), cracked, bulging or leaking (leaking at other than a proper connection).
• Stop arm does not fully extend to a right angle to the bus
• Washers do not function properly in any manner

• A heater motor is not operating properly

• Any rear tire has less than 2/32 inch tread depth when measured in any two adjacent major grooves
• A heater motor is not operating properly
• Upholstery or padding is ripped, torn, or improperly repaired
• Exhaust leak exceeding one (1) inch measurable in any direction or half (½) inch in diameter.
• There is fuel leaking from any point on in the fuel system

• Audible warning device, when required, is not working properly. Buzzers are required after 5-2-94

• A heater motor is not operating properly
• A dripping oil or fluid leak
• Any crossmember is rusted sufficiently to weaken floor supports
• There is no brake certification form the certification is expired or is not signed within the six-month requirement

• Any crossmember is rusted sufficiently to weaken floor supports

• Any exhaust leak can be felt with the bare hand six (6) inches from the leak in any direction (with the engine idling and the system unrestricted).
• A heater motor is not operating properly
• Any headlight is inoperative
• Any dome light is inoperative
• Any paint is badly faded or peeling

• Air leak at proper connection
• Any headlight is inoperative
• Any seat back or bottom is loose

• Any seat back or bottom is loose

• The strobe light is inoperative
• Tailpipe does not extend to, or extends beyond the perimeter of the bus body
• Any required padding is missing

• Audible warning device, when required, is not working properly. Buzzers are required after 5-2-94
• There is fuel leaking from any point on the fuel system.

• Tailpipe does not extend to, or extends beyond the perimeter of the bus body.
• Clearance light is missing, cracked, faded, wrong color, or inoperative.

• Crossmember is cracked or broken
• Crossmember is rusted sufficiently to weaken floor supports.

• Any headlight is inoperative.