PRIMROSE SCHOOL @ GRAY EAGLE

To view the full report for a bus inspection, click on the PDF icon on the right.

• The horn does not operate at all

• There is no brake certification, or the certification has expired or is not signed

• The reflective material is placed anywhere other than on the front and rear, or both, of the bus between the warning lamps; each side beltline, seat line, or floor line or all three (3); outlining each required emergency exit; or across the rear of the bus directly above the rear bumper.

• The bus with a body build date of January 1, 2006 or after is not equipped with the noise suppression switch. EXEMPTION Type A buses - w/out noise making devices other OEM accessories not including two-way, AM/FM, Satellite, or similar.

• The seat belt cutter does not have a full width handgrip, with a protective blade to minimize risk
• Any required lettering is missing or faded.
• The parking brake fails to hold the bus during the testing procedure. (Note – It is NOT a violation if the test cannot be done due to OEM design

• One (1) taillight or one (1) brake light does not function
• Any exhaust leak can be felt with the bare hand six (6) inches from the leak in any direction (with the engine idling and the system unrestricted).

• If bus manufactured after 5-2-1994, positive door opening device is missing or fails to operate properly

• There is lateral steering shaft movement
• Play can be measured at one (1) location on any steering component
• There is movement at any spring loaded drag link or the rod end (using hand pressure).
• Tie rod end movement is greater than 1/8 inch (rotational movement is acceptable)