Language Translation
  Close Menu

Emergency Action Plan

(29 CFR 1910.38 and 29 CFR 1926.35)

This is a sample written program whose intended usage is to serve only as a convenient guide for obtaining compliance with the applicable OSHA standard. It should be expanded, personalized, and tailored to your companies, places of business, or work sites.

This publication does not itself alter or determine compliance responsibilities, which are set forth in OSHA standards themselves and in the Occupational Safety and Health Act. Moreover, because interpretations and enforcement policy may change over time, for additional guidance on OSHA Compliance requirements, the reader should consult current administrative interpretations and decisions by the Occupation Safety and Health Review commission and the Courts.

Find a section fast:

I. Purpose

The purpose of an Emergency Action Plan is to protect the employees from serious injury, property loss, or loss of life in the event of a major disaster. A major disaster constitutes any one (1) of the following: fire - tornado - earthquake - violence in the workplace - bomb threat - hazardous chemical spill.

In the event of any disaster listed, this Emergency Action Plan describes the responsibilities and actions to be taken to protect all employees.

Back to top

II. General Procedures

In the event of a disaster, the warning may come from any one (1) of the following sources: commercial radio or television, civil defense radio, in-plant automatic sprinkler system, in-plant alarm, messenger, or police.

  1. Notification of Emergency Warning.

    A person receiving notification of a possible disaster, or an in-plant emergency should immediately notify their immediate supervisor. The type of disaster or emergency situation should then be conveyed to all employees with the use of the plant emergency alarm system.

  2. Emergency Control Committee

    The following personnel will constitute the Emergency Control Committee. In the event of a disaster or immediate emergency, they are to report to a designated emergency Control Center unless the prevailing situation dictates otherwise.

    Committee members are:

    1. Plant Manager
    2. Personnel director
    3. Safety director

    Responsibilities:

    1. Assess nature and extent of all emergencies
    2. Assume control of all emergency actions
    3. Assign tasks to personnel to carry out specific actions
    4. Order evacuation if deemed necessary
    5. Take any other action necessary to protect life
    6. Annually review plans and revised as necessary
    7. Plan training exercises to test evacuation plan
    8. Instruct personnel of their duties under this plan

    In any emergency situation, the ranking member of management present shall have final authority to coordinate procedures, and amend, modify or supersede any provisions of this plan in order to ensure employee safety.

  3. Emergency Control Center

    Emergency actions should be coordinated at the Emergency Control Center, which will be designated as the plant manager's office. If this office is not available, report to the most convenient office of the other two (2) committee members.

    If the emergency situation warrants the committee members to meet on the plant floor, it will be the plant manager's responsibility to notify, and give the location where members are needed.

  4. First Aid Services

    All first-line supervisors have been certified by the American Red Cross to provide first aid. They will be available to administer first aid in the plant, or in the event of a complete evacuation at a safe assembly area outside the plant.

  5. Utility Controls

    All maintenance personnel will know the location and operation of main controls for shutting off the gas, electricity, and water leading into the building.

  6. New Information

    Information to any source of news media will only be released at the discretion of the plant manager.

Back to top

III. Emergency Alarms

  1. ADT Sprinkler Alarm

    In the event of a fire, the ADT Sprinkler Alarms System will be activated automatically. Upon activation, the flow of water will begin in the area of the fire, and an alarm will sound throughout the building. Upon hearing the alarm, employees should, if time permits, shut off the power to the equipment they are operating and proceed to the evacuation sites indicated outside the building (see Appendix 1) and conduct a roll call.

  2. Action

    When the alarm is activated, at least one (1) member of the Emergency Control Committee should report to the evacuation site outside the plant (see Appendix 1). The other members should take necessary action to insure safety of the employees and notify proper agencies for any services that are needed.

  3. Plant-wide Evacuation Alarm (Continuous High Pitched Alarm)

    With the exception of a fire, employees should not evacuate the building unless authorized by the Emergency Control Committee. The signal/alarm for a plant-wide evacuation will be a continuous high-pitched alarm. Once at the assembly site, the first-line supervisor should conduct a roll call and report to a Emergency Control Committee member for assistance.

  4. Segmented Area Evacuation

    The signal/alarm for a segmented area evacuation will an intermittent high-pitched alarm. A first-line supervisor will have the authority to activate the alarm and give appropriate instructions to employees to insure safety. Before leaving, the first-line supervisor should inspect the area to ensure all employees are evacuated. Evacuated employees should report to the assembly site posted inside the building (see Appendix 2). Once at the assembly site, the first-line supervisor should conduct a roll call and report to an Emergency Control Committee member for assistance.

  5. Phone Listings

    A listing of all emergency telephone numbers is located at plant and office telephones (see Appendix 3). If the emergency occurs on the day shift, the switchboard operator will be responsible for contacting the appropriate agency. A member of the Emergency Control Committee should then be contacted for assistance.

Back to top

IV. Evacuation Sites

A map of all evacuation sites will be displayed in the lunchroom and all departments. Each map will show the route and exit to take depending where employees are located in the plant. It will be the responsibility of the first-line supervisor to inform employees of these evacuation routes.

Back to top

V. Procedure for Emergency Shutdown of Operations

An emergency shutdown will only be ordered from the highest-ranking member of the Emergency Control Committee. No employee should risk any type of injury to accomplish this task.

However, if time permits, the following personnel should perform the following duties:

  1. All warehouse and material handling personnel should drive forklift trucks out of aisles and exit ways.
  2. Maintenance department should shut off gas lines and electrical supply as instructed by the maintenance manager.

Back to top

VI. Tornado (Intermittent Alarm)

In the event of a tornado or a serve weather warning, the following procedure should be put in effect by the supervisor or emergency Control Committee:

  1. Listen for latest advisories on radio.
  2. Post outlooks for outside observation.
  3. If necessary, initiate emergency shutdown procedures.
  4. Move personnel into designated safe assembly areas within the building.
  5. After tornado passes, restore calm and check for injuries.

Back to top

VII. Earthquake (Intermittent Alarm)

An earthquake will usually occur without any type of warning. Due to the suddenness, all personnel should attempt to get into a doorway passage or under a table or desk. Any place where an employee feels safety is warranted. NO ONE SHOULD GO OUTSIDE THE BUILDING. After an earthquake has stopped, the following procedure should be initiated:

  1. All employees should help restore calm to fellow employees.
  2. Emergency Control Committee and first-line supervisors should check for injuries and provide first aid as needed.
  3. The maintenance department should check for fires and shut off all gas, electricity, and water at main controls.
  4. A member of the Emergency Control Committee for damage should inspect the building. If major structural damage has occurred, the Emergency Control Committee should order a complete evacuation.
  5. The Emergency Control Committee should then notify proper utility companies or other services as needed.

Back to top

VIII. Bomb Threat (Continuous High-Pitched Siren)

In the event of a bomb threat, which will normally be received over the telephone, the following procedure should be followed:

  1. The person receiving the bomb threat should complete the attached form (Appendix 4) as soon as possible and answer questions once the report has been turned over to the Emergency Control Committee.
  2. The Emergency Control Committee shall determine the appropriate procedures to be taken among the following:
    1. Commence immediate plant wide evacuation to outside evacuation sites
    2. Contact proper law enforcement agencies (Appendix 3)
    3. Contact the fire department (Appendix 3)
    4. Do not permit re-entry until the building has been searched and declared safe by bomb disposal unit.
  3. If a bomb threat is received by any other means than the telephone, the person receiving the threat should report immediately to their first-line supervisor or a member of the Emergency Control Committee.

Back to top

IX. Fire Prevention and Workplace Hazards

  1. It is the responsibility of all employees to prevent any type of fire in the building. Listed below is a list of general items to take into consideration to accomplish this objective:
    1. Extinguish all cigarettes in their proper place.
    2. Do not have open flame around any type of chemicals, paints, solvents, or flammable liquids
    3. Make sure all hand held torches are extinguished when not in use
    4. Do not put any type of hot object in trashcans; ie. cigarette butts
  2. Listing of Some Workplace Hazards
    1. Flammable Substances
      1. Paint and Paint Solvents
      2. Mineral Spirits
      3. Alcohol
      4. Propane Tanks for Fork Trucks
      5. Oxygen and Acetylene Tanks
      6. Hydraulic Oil
      7. Grease
    2. Welding Operations
      All welding operations will be done in a confined area unless, otherwise instructed by the maintenance manager. A fire extinguisher will be immediately available in case of an emergency.

Back to top

X. Control of Workplace Hazards

  1. All flammable and combustible materials will be stored in a designated area or flammable storage area.
  2. Good housekeeping will be the responsibility of ALL employees.
    1. Waste materials are to be discarded in their proper places.
    2. Operators are to pick up and sweep any debris on or around their machine on a shift-to-shift basis.
    3. All aisles and exits will be kept clear
    4. All painted areas to fire extinguishers will be kept clear for access
    5. All employees will know evacuation routes and exits to proceed to when instructed, if an emergency situation develops.
    6. All employees will be instructed on the company Emergency Action Plan
    7. Emergency telephone numbers will be posted at main receptionist desk, offices of Emergency Control Committee members and first-line supervisors
    8. Each first-line supervisor will be responsible for his or her shift employees to handle, store, and maintain hazardous materials properly

Back to top

XI. Maintenance of Fire Equipment and Systems

Maintenance Manager Responsibilities

  1. To have ADT run monthly checks of the water sprinkler system.
  2. Maintenance department will conduct monthly inspection of fire extinguishers and blanket locations. Any questions or problems should be conveyed back to the maintenance manager.
  3. An outside safety firm will run annual checks on all fire extinguisher equipment.
  • Appendix 1: Outside Evacuation
    Appendix 2: Segmented Area Evacuation
    Appendix 3: Emergency Telephone Listing
    • Emergency Number (Fire, Police, Ambulance)
    • Police Department
    • County Sheriff
    • Indiana State Police
    • FBI
    • Poison Information
    • U.S. Marshall
    • Civil Defense
    • (Electorial) Utility
    • (Gas) Utility
    • Water Department
    • Weather Report
  • Appendix 4: Bomb Threat Checklist
    • Instructions: Be calm and courteous.
    • Listen, do not interrupt caller.
      1. Name Of Operator:
      2. Time:
      3. Date:
      4. Callers Identity:
        Male / Female / Adult / Juvenile
      5. Origin Of Call:
        Local / Long Distance / Booth / Internal
      6. Specifics About Bomb:
        1. Keep Caller Talking If Caller Is Agreeable To Further Conversation.
        2. Ask Questions Like: When Will Bomb Go Off?
          What Is Your Present Location?
          Location Of Bomb?
          What Is Your Name And Address?
          What Kind Of Bomb?
          How Do You Know So Much About The Bomb?
        3. Did Caller Appear Familiar With Plant Or Building By His/Her Description Of Bomb Location?
        4. After Call Is Taken, Notify At Once A Member Of The Emergency Control Committee

Back to top